DAP -12S Vacuum pump set

DAP -12S Vacuum pump set
  • PDFdata
  • DXFdata

DAP-12S is a diaphragm type vacuum pump that uses the reciprocating motion of a rubber film.
No oil is used, so the exhaust from the unit keeps the environment clean and maintenance is easy.
The unit comes with an accessory 1.5m vinyl hose (φ8 x φ11), coupling joint JT-1, and a special nipple.

Specifications Unit 50Hz 60Hz
Effective exhaust velocity L/min. 12 14
Ultimate pressure Torr (Pa) 24.0×103 (-77.3kPa)
Motor used Single phase. 100V.10W.
4poles.capacitor run
Full-load current A 0.5
Mass kg 1.9
Suction hose diameter mm (Rc 1/8)
Atmospheric temperature range °C 0-40
Maximum dimensions mm 93(W) x 163(L) x 100.6(H)
RoHS Compliant Compliant

The ultimate pressure figure in parentheses ( ) is the gauge pressure display.

JT-5 multi-hose joint

JT-5 multi-hose joint
  • PDFdata
  • DXFdata

Air hoses can be inserted into every port of the vacuum pump and air pit, and up to 5 air pits can be operated simultaneously.
Multiple air pits can be operated by a single pump. This application is very useful and economical.

JT-1 single-hose joint

JT-1 single-hose joint
  • PDFdata
  • DXFdata

The JT-1 connects a single air hose between a vacuum pump and an air pit.The standard DAP-15 package contains a single JT-1 joint

AP-DLS Dust and liquid stockert

AP-DLS Dust and liquid stockert
  • PDFdata
  • DXFdata

When the Air Pit is used for object suction, different types of dust particles may be sucked in at the same time, including liquid particles of water and oil that may be adhering to the surface of the object being handled. The purpose of the dust and liquid stocker is to collect these particles before they reach the vacuum source, and so protect the vacuum source.
The collected dust and liquid particles can be easily removed, and the filter easily cleaned. The stocker is essential if the Air Pit is to be used for cleaning very small objects.
Note, however, that the stocker cannot be used to take in a large amount of liquid at one time.

Silicone hose

Silicone hose

The silicone hose (φ3 xφ5) comes as an accessory with the Air Pit.
If a length of longer than the 1m included is required, the hose is cut and sold in units of 1 meter.

stand AP-ST

stand AP-ST

This easy to use stand has clips on both sides and holds the Air Pit.

SP-J Spiral tube hose joint

SP-J Spiral tube hose joint
  • PDFdata
  • DXFdata

This special hose joint is for connection to a commercially available spiral hose (φ4 x φ6 ).